Questions and Answers
Questions & Answers
avatar
Recent Questions

avatar
Guest  •  1 year ago
avatar
⚙️Leading Edge  •  1 year ago
It's made of plastic, but the top part is a flat surface where you place your angle cube.
0 | 0
avatar
JT  •  1 year ago
Will the 4" stone holder enable me to use my Venev dual sided diamond stones with my KME system?
avatar
NYCJay  •  1 year ago
Yes. As long as your venev dual sided stones are the 4 inch and not the 6 inch. Just be careful not to torque down the tightening knob too much on the 3D printed stone holder. Just snug it up until the stone doesn't easily move or you'll eventually crack one of the ends of the holder and have to gorilla glue it like I did. Leading Edge recommends using a small piece of duct type tape on the ends of your square ended stones to make them grip better and that helps.
0 | 0
avatar
Guest  •  2 years ago
avatar
⚙️Leading Edge  •  2 years ago
Just the stone holder. You use the original KME rod and screw it into the stone holder, similar to the original KME stone holder. There is a steel nut thread in the back that you screw the original KME rod into.
0 | 0
View all
view